Venza FWD V6-3.5L (2GR-FE) (2010)
/Page-2027001.png)
Impact Sensor: Testing and Inspection
Front Airbag Sensor
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: ON-VEHICLE INSPECTION
CAUTION:
Be sure to follow the correct removal and installation procedures of the front airbag sensor.
1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
(b) Visually check the front airbag sensors for defects if the front bumper of the vehicle or the area around the bumper is damaged.
(1) The defects are as follows:
*
Cracks on the sensor housing
*
Dents on the sensor housing
*
Chips on the sensor housing
*
Cracks or other damage to the connector
*
Peeling of the label
*
Damage to the serial number
OK:
No defects are found.
HINT
If any of the defects is found, replace the front airbag sensor with a new one.
3. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
(a) When airbags have deployed as the result of a collision, be sure to replace all front airbag sensors in the damaged areas (anywhere in need of
repair).
(b) Visually check the front airbag sensors in undamaged areas for defects.
(1) The defects are as follows:
*
Cracks on the sensor housing
*
Dents on the sensor housing
*
Chips on the sensor housing
*
Cracks or other damage to the connector
*
Peeling of the label
*
Damage to the serial number
OK:
No defects are found.
