Venza FWD V6-3.5L (2GR-FE) (2010)
Oil Pressure Sender: Service and Repair
Removal
2GR-FE LUBRICATION: OIL PRESSURE SWITCH: REMOVAL
1. REMOVE FRONT WHEEL RH (w/ Oil Cooler)
2. REMOVE NO. 1 ENGINE UNDER COVER (w/o Oil Cooler)
3. REMOVE NO. 2 ENGINE UNDER COVER (w/o Oil Cooler)
4. SEPARATE FRONT FENDER LINER RH (w/ Oil Cooler)
5. REMOVE FRONT FENDER APRON RH (w/ Oil Cooler)
6. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY (w/o Oil Cooler)
(a) Disconnect the oil pressure switch assembly connector.
(b) Using a 24 mm deep socket wrench, remove the oil pressure switch.
7. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY (w/ Oil Cooler)
(a) Disconnect the oil pressure switch assembly connector.
(b) Using a 24 mm deep socket wrench, remove the oil pressure switch.