Venza FWD V6-3.5L (2GR-FE) (2010)
/Page-467004.png)
Text in Illustration
HINT
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting,
as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the side airbag sensor.
2. INSTALL LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat
Outer Belt Assembly/Installation
4. INSTALL LAP BELT OUTER ANCHOR COVER See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer Belt
Assembly/Installation
5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation
6. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation
8. INSTALL FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
10. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
11. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
