Venza FWD V6-3.5L (2GR-FE) (2010)
Seat Position Sensor: Testing and Inspection
SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: ON-VEHICLE INSPECTION
CAUTION:
Be sure to follow the correct removal and installation procedures of the seat position sensor.
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
(b) Visually check for defects with the seat position sensor installed on the vehicle.
(1) The defects are as follows:
*
Cracks on the sensor housing
*
Dents on the sensor housing
*
Chips on the sensor housing
*
Cracks or other damage to the connector
OK:
No defects are found.
HINT
If any of the defects is found, replace the seat position sensor with a new one.