Venza FWD V6-3.5L (2GR-FE) (2010)
Tire Pressure Module: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Connect the connector to the tire pressure warning ECU.
(b) Install the tire pressure warning ECU with the nut.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
HINT
Engage the tab into the hole as shown in the illustration to install the tire pressure warning ECU.
2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
5. INSTALL FRONT DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
7. REGISTER TRANSMITTER ID
HINT
It is necessary to register all transmitter IDs See: Wheels and Tires/Tire Monitoring System/Testing and Inspection/Programming
and Relearning.