Venza FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
NOTICE:
Ensure that the identification mark faces the rear side of the vehicle.
(b) Temporarily install the rear No. 2 suspension arm assembly LH to the rear axle carrier sub-assembly LH with the bolt (A) and the nut.
NOTICE:
Since a stopper nut is used, temporarily tighten the bolt.
4. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
(a) Temporarily install the rear No. 2 suspension arm assembly RH to the rear suspension member with the bolt (B).
Text in Illustration
NOTICE:
Ensure that the identification mark faces the rear side of the vehicle.
(b) Temporarily install the rear No. 2 suspension arm assembly RH to the rear axle carrier sub-assembly RH with the bolt (B) and the nut.
NOTICE:
Since a stopper nut is used, temporarily tighten the bolt.
5. CONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ HID Headlight System)
(a) Connect the rear height control sensor sub-assembly to the rear No. 2 suspension arm assembly RH with the nut.