Venza FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
NOTICE:
Do not bend the brake dust cover.
(b) Jack up the rear axle carrier sub-assembly LH to set the rear No. 2 suspension arm assembly LH in the tightening position as shown in the
illustration.
Standard angle (A):
4°36' (4.6°)
Standard length (B):
39.1 mm (1.54 in.)
CAUTION:
Do not jack up the rear axle carrier sub-assembly LH too high as the vehicle may fall.
HINT
If the rear No. 2 suspension arm assembly LH cannot be positioned as shown in the illustration even when the rear axle carrier
sub-assembly LH is jacked up, apply additional load to the vehicle such as by having a person sit in the rear seat.
(c) Fully tighten the bolts in the tightening position.
Bolt (A) - Torque : 112 Nm (1142 kgf-cm, 83 ft-lbf)
Bolt (B) - Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)
NOTICE:
Since a stopper nut is used, fully tighten the bolt (A) and (B).
10. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH