Venza FWD V6-3.5L (2GR-FE) (2010)
Nut B - Torque : 38 Nm (387 kgf-cm, 28 ft-lbf)
(d) Install the rear suspension member and rear lower suspension member stoppers with the 2 bolts.
Torque : 55 Nm (561 kgf-cm, 41 ft-lbf)
NOTICE:
Be sure to install the rear suspension member with the rear lower suspension member stoppers in the correct direction shown in the
illustration.
10. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH See: Control Arm/Service and Repair/Rear Lower
Arm/Installation
11. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY RH See: Control Arm/Service and Repair/Rear Lower
Arm/Installation
12. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH See: Control Arm/Service and Repair/Rear Lower
Arm/Installation
13. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY RH See: Control Arm/Service and Repair/Rear Lower
Arm/Installation
14. INSTALL LOWER NO. 1 EXHAUST PIPE SUPPORT BRACKET
(a) Install the lower No. 1 exhaust pipe support bracket with the 2 bolts.
Torque : 33 Nm (337 kgf-cm, 24 ft-lbf)
15. INSTALL CENTER EXHAUST PIPE ASSEMBLY
(a) Install the center exhaust pipe assembly.
HINT
Refer to the instructions for Installation of the exhaust pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service
and Repair/Installation for 2GR-FE, See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and