Venza FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
*
Do not remove the front suspension support nut.
*
Loosen the nut only when the front shock absorber with coil spring needs to be disassembled.
6. REMOVE FRONT FENDER TO COWL SIDE SEAL LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Removal
7. REMOVE FRONT FENDER TO COWL SIDE SEAL RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Removal
8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front
Wiper Motor/Removal
9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front
Wiper Motor/Removal
10. REMOVE OUTER COWL TOP PANEL
(a) Disengage the 2 clamps and separate the wiper wire harness from the outer cowl top panel sub-assembly.
(b) Disengage the 2 clamps and connector, and separate the wire harness from the outer cowl top panel sub-assembly (w/ Windshield Deicer).
(c) Remove the 4 bolts, 4 nuts and outer cowl top panel sub-assembly.