Venza FWD V6-3.5L (2GR-FE) (2010)
Control Module: Service and Repair
Removal
U660E AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: REMOVAL
NOTICE:
If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional
operations are necessary See: Transmission Control Systems/Service Precautions.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
3. REMOVE INLET NO. 2 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
4. REMOVE BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
5. REMOVE INLET NO. 1 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
6. REMOVE TCM
(a) Turn the lock lever and disconnect the connector from the TCM.
(b) Remove the 2 bolts and TCM from the transaxle.