Venza FWD V6-3.5L (2GR-FE) (2010)
Transmission Temperature Sensor/Switch: Service and Repair
Installation
U660E AUTOMATIC TRANSMISSION / TRANSAXLE: ATF TEMPERATURE SENSOR: INSTALLATION
1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY
(a) Coat a new O-ring with ATF and install it to the ATF temperature sensor assembly.
Text in Illustration
(b) Coat the 4 bolts with ATF.
(c) Install the ATF temperature sensor assembly and clamp to the valve body with the 4 bolts.
Text in Illustration
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
Bolt length:
Bolt A
25 mm (0.984 in.)
Bolt B
85 mm (3.35 in.)
(d) Connect the connector.
2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY See: Valve Body/Service and Repair/Removal and Replacement/Installation
3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY See: Valve Body/Service and Repair/Removal and
Replacement/Installation
4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
HINT
See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" See: Service and
Repair/Removal and Replacement/Installation.