Venza FWD V6-3.5L (2GR-FE) (2010)
(b) Remove the front drive shaft damper.
9. REMOVE NO. 2 FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) Using pliers, remove the No. 2 front axle outboard joint boot clamp as shown in the illustration.
10. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) Remove the front axle outboard joint boot clamp.
HINT
Perform the same procedure as for the No. 2 front axle outboard joint boot clamp.
11. REMOVE FRONT AXLE OUTBOARD JOINT BOOT
(a) Remove the front axle outboard joint boot from the front drive outboard joint shaft assembly.
(b) Remove the grease from the front drive outboard joint.
12. REMOVE FRONT DRIVE SHAFT DUST COVER LH (for LH Side)
(a) Using SST and a press, remove the front drive shaft dust cover LH.
SST : 09950-00020
NOTICE:
Be careful not to drop the inboard joint assembly.
13. REMOVE FRONT DRIVE SHAFT DUST COVER RH (for 2WD RH Side)
(a) Using a press, remove the front drive shaft dust cover RH.