Yaris L4-1.5L (1NZ-FE) (2007)
/Page-1390005.png)
3.
Push down on the SST tool and install the torsion bar to the LH hinge arm.
4.
Install the RH trunk lid hinge torsion bar to the clip on the center of the upper back panel.
Install LH hinge torsion bar
Use the same procedure for the LH side as the RH side.
^
Prior to installation, make sure the correct torsion bars are being installed.
^
A yellow paint mark is used on torsion bars for vehicles wlo rear spoiler.
^
A green paint mark is used on torsion bars for vehicles with a rear spoiler.
1.
Install the LH torsion bar to the RH hinge support and attach the SST.
2.
Push down on the SST and install the torsion bar to the LH hinge arm.
3.
Install the LH trunk lid hinge torsion bar to the clip on the center of the upper back panel.
