Yaris L4-1.5L (1NZ-FE) (2007)
/Page-1392007.png)
CAUTION: Do not burn yourself with the heated back door panel or infrared light.
HINT: Heat at 40 to 60° C (104 to 140° F) for 1 to 2 minutes.
c. Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the No. 2 luggage compartment
door name plate.
d. Remove the protective tape.
INSTALLATION
1. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
a. Clean the attachment surface.
1. Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.
HINT: Heat at 40 to 60° C (104 to 140° F) for 1 to 2 minutes.
2. Using a shop rag or piece of cloth, rub the double-sided adhesive tape off the back door panel while it is hot from the infrared light.
NOTICE: Installing the No. 2 luggage compartment door name plate while any double-sided tape remains on the back door panel may
cause adhesion failure. Therefore, completely remove the double-sided tape.
3. Using a non-residue solvent, clean the attachment surface.
b. Install a new No. 2 luggage compartment door name plate as shown in the illustration.
NOTICE: Install the No. 2 luggage compartment door name plate in an environment where the ambient temperature is over 20° C (68° F). If
it is below 20° C (68° F), using an infrared light, heat the back door panel and the No. 2 luggage compartment door name plate up to 20 to 30°
C (68 to 86° F) and install the No. 2 luggage compartment door name plate.
2. INSTALL NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE
