toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Interior - Park Brake Lever Boot Catches on Console|Page 4499 > < Interior - Park Brake Lever Boot Catches on Console
Page 2
background image

1.

Remove the console box carpet.

2.

Loosen the two (2) mounting bolts and slide the console assembly forward as far as possible.

3.

Tighten the two (2) mounting bolts.

4.

Fully engage the parking brake.

5.

Measure the distance between the front of the boot and the console opening.

NOTE:

^

If clearance is MORE than 2.5 mm (0.1 in.), the repair is complete.

^

If this distance is LESS than 2.5 mm (0.1 in.), go to "Remove & replace brake dust boot" section of the Repair Procedure to replace the
parking brake dust boot.

Remove & replace parking brake dust boot:

Please refer to "Removal" section in the Technical Information System (TIS), 2007 model year Yaris Repair Manual: Instrument Panel: Rear
Console Box (for Sedan): Removal, Disassembly, Reassembly, Installation.

1.

Disconnect the cable from the negative (-) battery terminal.

2.

Remove the instrument panel finish panel lower center.

3.

For manual transmission vehicles:

Remove the shift lever knob sub-assembly.

Interior - Park Brake Lever Boot Catches on Console|Page 4499 > < Interior - Park Brake Lever Boot Catches on Console