toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Procedures|Page 332 > < Component Tests and General Diagnostics|Page 329
Page 1
background image

Engine Control Module: Procedures

Registration

REGISTRATION

NOTE:  The Vehicle Identification Number (VIN) must be input into the replacement ECM.

HINT:  The VIN is a 17-digit alphanumeric number. An intelligent tester is required to register the VIN.

1. DESCRIPTION

This registration section consists of three parts, Input Instructions, Read VIN and Write VIN.
a. Input Instructions: Explains the general VIN instructions for when using an intelligent tester.
b. Read VIN: Explains the VIN reading process flowchart. This process allows the VIN stored ECM to be read, in order to confirm that the

VINs, provided with the vehicle and stored in vehicle's ECM, are the same.

c. Write VIN: Explains the VIN writing process flowchart. This process allows the VIN to be into the ECM. If the ECM is changed, or the VIN

VIN do not match, the VIN can be registered, overwritten in the ECM by following this procedure.

2. INPUT INSTRUCTIONS

a. Intelligent tester The arrow buttons (UP, DOWN, RIGHT and and numerical buttons (0 to 9) are used to input VIN.
b. Cursor Operation To move the cursor around the tester screen, the RIGHT and LEFT buttons.
c. Alphabetical Character Input

1. Press the UP and DOWN buttons to select desired alphabetical character.
2. After selection, the cursor should move.

d. Numeric Character Input

1. Press the numerical button corresponding the number that you want to input.
2. After input, the cursor should move.

HINT:  Numerical characters can also be selected by using the UP and DOWN buttons.

e. Correction

1. When correcting the input character(s), cursor onto the character using the RIGHT LEFT buttons.
2. Select or input the correct character using UP/DOWN buttons, or the numerical buttons.

f.

Finishing Input Operation
1. Make sure that the input VIN matches the vehicle VIN after input.
2. Press the ENTER button on the tester.

3. READ VIN

a. Confirm the vehicle VIN.
b. Connect the intelligent tester to the DLC3.
c. Turn the ignition switch to ON.
d. Turn the tester ON.

Procedures|Page 332 > < Component Tests and General Diagnostics|Page 329