Yaris L4-1.5L (1NZ-FE) (2007)
3. After detaching the connector confirm that the CPA protrudes beyond the rear of the housing.
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Refer to Restraint Systems Service Precautions before before
servicing.
HINT: The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides unless otherwise specified.
1. INSTALL FRONT AIRBAG SENSOR
NOTE:
-
Do not use a front airbag sensor that has been dropped.
-
Do not subject the front airbag sensor any impact or force.
a. Confirm that the ignition switch is turned to off.
b. Confirm that the negative battery terminal is detached.
CAUTION:
-
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag
sensor will cause the airbag to deploy.
-
Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.