toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Procedures|Page 6906 > < Procedures|Page 6904
Page 93
background image

NOTE:  Replace the special clip with a new one when the roof side inner garnish is removed.

1. Disengage the 5 clips.
2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner

garnish.

c. w/o Curtain Shield Airbag:

1. Disengage the 5 clips.
2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner

garnish.

22. REMOVE ROOF SIDE INNER GARNISH LH
23. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY

a. Remove the 2 tongue plates.

b. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and open the slip joint cover.

Procedures|Page 6906 > < Procedures|Page 6904