Yaris L4-1.5L (1NZ-FE) (2007)
/Page-1308024.png)
HINT: When removing the deck side trim panel assembly LH disconnect the room light connector and remove the deck side trim panel.
18. REMOVE REAR AIRBAG SENSOR
CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the
airbag sensor will cause the airbag to deploy.
a. Slide the outer housing and detach the airbag connector.
b. Remove the bolt disengage the hook and remove the airbag sensor.
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing.
NOTE: Always use "Torx" socket wrench E10 when installing the rear seat.
HINT: The procedure described below is for the RH side. Use the same procedure for both the LH and RH sides unless otherwise specified.
1. INSTALL REAR AIRBAG SENSOR
a. Confirm that the ignition switch is turned to OFF.
b. Confirm that the negative battery terminal is detached.
CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the
airbag sensor will cause the airbag to deploy.
