Yaris L4-1.5L (1NZ-FE) (2007)
/Page-1679011.png)
-
Throw away any leftover Primer M.
-
Do not apply too much Primer M.
c. Using a brush or sponge, apply Primer G to the edge of the windshield glass and the contact surface.
NOTICE:
-
Allow the primer to dry for 3 minutes or more.
-
Throw away any leftover Primer G.
-
Do not apply too much Primer G.
HINT: If Primer G is applied to any areas other than those specified, wipe off the primer with a clean shop rag or piece of cloth before it
dries.
d. Apply adhesive.
Adhesive:
Part No. 08850-00801 or the equivalent
1. Cut the tip off the cartridge nozzle, as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the times indicated in the table below.
