A Pillar, Replace - Models 51, 52, 53, 54, 55, 56, 57, 58, 59
 Remove, Disconnect Attaching parts. Drill off wheel housing brace. Separate A pillar - cut section 1. Note size of new part. On partial replacement of A pillar (separation at belt line) - cut section 2. | 
|
 Install, Connect Fit A-pillar. Prepare flanges, apply spot weld paint. Weld in A-pillar and wheel housing strut. Attaching parts. | 
|
 Important! A pillar is supplied with tack-welded door hinges. Attach front door at hinges and adjust door gap according to dimensional specifications. Dimensions deviate from body-in white door to complete door. The body-in-white door closes without inner door seal.
|
Position |
Door shell |
Complete door |
|
1 |
4 |
4,5 |
|
2 |
5 |
5,5 |
All dimensions in mm. tolerance ± 1 mm/0.394 in.
Install, Connect | 
|
Weld in hinges (1), seal welding seams (2). Seal cavities. Attaching parts | 
|
|
