Folding Hood Inner Covering, Replace - Model 53-B
 Remove, Disconnect Rear external covering - see operation "Folding hood external covering, replace - Model 53-B". Folding hood insulation mat - see operation "Folding hood insulation mat, replace - Model 53-B". Velcro (2), drill off fastening rivet (1) - 2 rivets on each side. | 
|
Inner covering from bow - loosen cement. Inner covering from rear roof frame - loosen cement. | 
|
Remove, Disconnect Retainer strips (1) from rear bow - mark retainer strips. Drill out fastening rivet - 8 rivets (arrows) Rubber tensioner (2) right and left. | 
|
Remove, Disconnect Sound deadening mat from bow. Drill off fastening rivets - 5 rivets on each bow.
 Important! Remove remains of rivets. | 
|
Remove, Disconnect Front inner covering, wire (1). | 
|
Sound deadening mat from bow. Drill off front fastening rivet - 1 rivet per side.
 Install, Connect Rivet front inner covering - 1 rivet on each side - 3.9 x 9 mm/0.15 x 0.35 in. Wire (1) - illustration E 4042, front inner covering. | 
|
Install, Connect Inner covering to bow. Firmly rivet internal cover - 8 rivets 3.9 x 9 mm. Only insert rivets (1) after inserting the folding hood sound deadening mat. | 
|
Install, Connect Rail internal cover - fastening hole (1) must be aligned. Align internal cover (2) with holding strip (3) with rear crossrail. Punch through fastening holes - 10 holes. | 
|
Install, Connect Place support (3) on internal cover, tension belts (1) on support, holding strip (2) and fix with rivets. Rivet holding strips (4) - 8 rivets 3.9 x 14 mm. | 
|
Install, Connect Rivet internal cover to crossrail - 2 rivets 3.9 x 11 mm. | 
|
Cement internal cover to rear roof frame - commercially available adhesive based on nitrile rubber. Cement internal cover to crossrail - commercially available adhesive based on nitrile rubber. |
|
Install, Connect Rivet internal cover to crossrail (1) - 2 rivets per side, 3.9 x 9 mm, adhesive strap (2). Folding hood sound deadening mat, rear external covering. |
|
|
