Rubber Weatherstrip, A Pillar, Replace - Model 53-B
Remove, Disconnect Open folding hood. Push A pillar rubber weatherstrip (3) from guide rail (1) and guide pin (2). |
|
Install, Connect Remove adhesive from adherend area A pillar (1) with masking tape and coat with primer made of 2-pack glass cement. Heat rubber weatherstrip A pillar in the adherend area (2) with a hot air dryer. |
|
Install, Connect Push A pillar rubber weatherstrip (3) onto guide pin (2) and guide rail (1). Align A pillar rubber weatherstrip at top. Remove protective backing and press on. Close folding hood. |
|
Inspect Check seating of A pillar rubber weatherstrip. |
|
|