Shell (glass) - see operation "Shell (glass), replace", water deflector panel - see operation "Water deflector panel (gutter), replace", crank drive or electric drive - see operation "Crank drive, remove and install" or "Electric drive, remove and install".
Push cable guide with slide block guide to stop in guide rail.
Adjust
Push cable guide backwards until connecting pin (1) aligns with rail adjusting grooves (2). Hold-down slider (3) passes rear edge of rail projection with minimum offset (0.2 - 0.5 mm/0.08 - 0.2 in.).
Install, Connect
Crank drive or electric drive, water deflector panel, shell (glass).
Remove, Disconnect 
Adjust 
Install, Connect 