Engine OFF
Note:
After an ignition OFF / ON
procedure, the TC control unit sends test signals via Ter. 5 and 21 to the
Motronic M 2.8 control unit (Ter. 50 and 38). These test signals can be
observed in the currently selected TECH 1 parameter and the corresponding
Motronic TECH 1 parameter.
It is important to wait some
time after ignition OFF, to allow the two control units in question adequate
time for a correct shut down procedure.
If the test signals cannot be
observed, the following checks for these parameters must be performed, as
these checks likewise cause the TC control unit to send corresponding
engagement signals in a normal operating mode.
Model Year '92 / 93
Vehicle stationary
|