vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0: Data List - Test Step 01 BATTERY VOLTAGE > < Checking with TECH 1

Abbreviations, Definitions

 

INTAKE AIR TEMP.                                         =       Intake air temperature

 

COOLANT TEMP.                                            =       Coolant temperature

 

MASS AIR FLOW S.                                        =       Hot film mass air flow meter signal

 

TPS SIGNAL                                                     =       Signal from throttle valve potentiometer

 

ENGINE LOAD SIG.                                        =       Engine load in ms, calculated from hot film mass air flow meter signal

 

TORQUE CONTROL                                       =       Engine torque in AT vehicles is reduced via the pre-ignition during shifting

 

IAC ADAPT. SLOPE                                        =       Pulse ratio of idle speed adjuster

 

IAC INTEGRATOR                                           =       Integrator value of idle speed adjuster

 

IAC BLOCK LEARN                                        =       Pattern recognition value of idle speed adjuster

 

02 SENSOR LOOP                                           =       Open/closed loop via oxygen sensor

 

02 INTEGRATOR                                              =       Integrator value of mixture - (02) - correction

 

02 BLM IDLE THR.                                          =       Learned mixture characteristic curve at idle speed

 

02 SENSOR                                                       =       Oxygen sensor voltage in mV

 

02 BLM PART THR.                                         =       Learned mixture characteristic curve in partial load range

 

BATTERY VOLTAGE                                      =       Control unit voltage supply

 

VEHICLE SP.PULSE                                       =       Odometer frequency sensor

 

INJECTION PULSE                                          =       Injection period in ms

 

ENGINE SPEED                                               =       Engine speed at idle speed

 

SPARK ADVANCE                                           =       Firing angle BTDC calculated by control unit

 

SIM. IDLE POS.SW                                          =       Idle position of throttle valve potentiometer

 

SIM. FULL POS.SW                                         =       Full load position of throttle valve potentiometer

 

FUEL TANK VENT.                                         =       Tank vent valve

 

PARK/NEUTRAL SW.                                      =       Switch for selector lever position P/N

 

A/C CUTOFF RELAY                                      =       AC cutoff relay for AC compressor cutoff

 

HFM                                                                   =       Hot Film Mass Air Flow Meter

 

ECU                                                                   =       Electronic Control Unit

 

Master Cartridge                                                =       Program Module

 

TECH 1 SELF-Test Routine                              =       TECH 1 self-test

 

PWM                                                                  =       Pulse Width Modulated signal (throttle valve potentiometer) from Motronic control unit to transmission control unit

 

TVP                                                                    =       Throttle Valve Potentiometer

 

EOT                                                                    =       Engine Oil Temperature

 

TFT                                                                     =       Transmission Fluid Temperature

 

F0: Data List - Test Step 01 BATTERY VOLTAGE > < Checking with TECH 1