Astra F
Table 4, Notes on "Engine Does Not Start"
Table 4 lists the tests required for when TECH 1 receives data from the control unit, no trouble codes are stored, but the engine still does not start.
· Connect TECH 80
After vehicle identification, select test program "Workshop Test"
In this display, all information required for correct starting of the engine is collected, evaluated and displayed. If the OPEL/VAUXHALL tester is not available, carry out the following checks:
· Battery (see also F0: DATA LIST, test step 01)
· Starter
· Compression
· Primary voltage
· Secondary voltage (see also F0: DATA LIST, test step 29)
· CO and CH measurements
· Injection signal (see also F0: DATA LIST, test step 43 and F8: ECU CONTROL, test step 03)
· Engine speed signal from inductive pulse pick-up (see also F0: DATA LIST, test step 29)
· Signal from Hall sensor (see F0: DATA LIST,test step 10)
|
||||||||||||
|