Vauxhall Workshop Service and Repair Manuals

Oxygen Sensor, Remove and Install  

  Important!   

Remove oxygen sensor only with engine at operating temperature.  

  Remove, Disconnect   

Separate wiring harness plug (1) of the oxygen sensor. Unscrew oxygen sensor (2) from exhaust manifold.     Important!    When lambda probe is reused, insert the thread of the lambda probe with special grease (black). Ensure correct cable laying - lay the cable of the lambda probe in such a way that it is not chafed and cannot reach the exhaust pipe.     Install, Connect    Screw oxygen sensor into exhaust manifold - 30 Nm/22 lbf. ft. Connect wiring harness plug for oxygen sensor.