42
|
EST LINE
COIL
CYL 1+4
VOLTAGE HIGH
|
16
|
· The control unit has determined a voltage level
at output Ter. D 10 to ignition module (EST lead) during starting which does
not correspond to the nominal value (6 consecutive 12 V to 0 V transitions
were not registered)
· (Short circuit to battery voltage)
If
trouble code 41 was recognized, the EST lead (C 3) is switched off.
Note:
A
fault in the control unit programming means that the TECH 1 display changes
between "TC PRESENT" and "TC NOT PRESENT" as soon as a
fault is recognized.
If
trouble code 42 was recognized, the system telltale is switched on.
If
trouble code 42 was recognized, the system telltale remains switched on until
the ignition is switched off.
|
Only
for control units as of Model Year 93
|