Ignition Distributor, Remove and Install (C 14 SE up to MY '93 1) and 14 SE)
Set 1st cylinder to TDC - see operation "Timing, Check (1.4 / 1.6 Ltr. Engines except 16 LZ2)".
Mark position of ignition distributor and camshaft housing.
Remove, Disconnect
Detach wiring harness plug. Remove distributor cap, ignition distributor shackle and ignition distributor.
Install, Connect
Set ignition distributor to mark. Tighten ignition distributor shackle by hand, attach distributor cap and connect wiring harness plug.
Inspect
Ignition adjustment. Tighten shackle fastening nut - 8 Nm/6 lbf. ft.
1) As of MY '93 DIS ignition module - see operation "DIS Ignition Module, Remove and Install".
Remove, Disconnect 
Install, Connect 
Inspect 