Multec (X 12 SZ / X 16 SZ) F0: DATA LIST
No.
TECH 1 Display
Conditions for Checking
Nominal Value
Trouble Codes
Terminal
42
IDLE ADJUST P-N
Nominal idle speed has not been reprogrammed (basic setting after control unit reset)
INACTIVE
Nominal idle speed has been programmed.
ACTIVE
Vehicles with AT
NOT USED
Trouble - shooting:
Nominal Value:
Cause of Fault:
(If nominal value is not attained)
· Program a new idle speed in the TECH 1 menu F6: F0: ADJUSTMENTS.
· Read off value in the TECH 1 menu F0: DATA LIST no.: 42
· In the TECH 1 menu F6: Fl ECU RESET
· Control unit defective