· The control unit
has determined a voltage level at output Ter. C 3 to ignition module
(EST lead) during starting which does not correspond to the nominal value (6
consecutive 12 V to 0 V transitions were not registered)
· (Short circuit to
battery voltage)
If trouble code 41 was recognized, the EST lead (C 3)
is switched off.
Note:
A fault in the control unit programming means that the
TECH 1 display changes between "TC PRESENT"
and " TC NOT PRESENT "
as soon as a fault is recognized. If trouble code 41 was recognized, the
system telltale is switched on.
If trouble code 41 was recognized, the system telltale
remains switched on until the ignition is switched off.
|