· The control unit has determined a voltage level
at output Ter. D 10 to ignition module (EST lead) during starting which does
not correspond to the nominal value (6 consecutive 0 V to 12 V transitions
were not registered)
· (Short circuit to ground)
If
trouble code 64 was recognized, the EST lead (D 10) is switched off.
Note:
A
fault in the control unit programming means that the TECH 1 display changes
between "TC PRESENT" and TC NOT PRESENT" as soon as a fault is
recognized.
If
trouble code 64 was recognized, the system telltale is switched on.
If
trouble code 64 was recognized, the system telltale remains switched on until
the ignition is switched off.
|