Wiring harness for solenoid valves, replace (AF 20)
Solenoid Valve Wiring Harness, Replace (AF 20)
Remove, Disconnect
Retaining plate for wiring harness beside selector lever position switch.
Side cover from transmission - in this group.
Wiring harness plug from solenoid valves or pressure regulator solenoid valve. Wiring harness plug (outer) from wiring harness for transmission; remove wiring harness from cable bracket and guide outwards.
Install, Connect
Install wiring harness with new rubber seal o-ring from outside inwards. Insert wiring harness in corresponding cable bracket (2, 7) and connect to the solenoid valves (1, 3, 5, 6) or fluid pressure regulator (4) (different cable lengths). Wiring harness plug (outer) to wiring harness for transmission. Retaining plate for wiring harness to transmission - tightening torque 13 Nm/ 9.5 lbf. ft. Install side cover - see operation "Gasket for Side Cover, Replace"; check transmission fluid level - see operation "Transmission Fluid Level, Check".
Remove, Disconnect 
Install, Connect 