Drive Gears (Driving and Driven), Remove and Install Transmission installed. Remove and install drive gear (driven):
 Remove, Disconnect Differential transmission - refer works instruction "Reconditioning Differential Transmission - F 13/15" or " Reconditioning Differential Transmission - F 18/F 18+".
|
Differential housing in vice, |
F 10/F 13: |
KM-520 |
|
|
F 15: |
KM-458-A |
|
|
F 16/F 18/F 18+/ F 20: |
KM-524-A |
|
Knock off drive gear from differential housing with brass drift. |
 Torque - Angle Method Rotate drive gear in differential housing (F 10/F 13/F 16/F 18/F 18+/F 20), 70 Nm/51.5 lbf. ft plus 30 ° to 45 ° . Drive gear into differential housing (F15), 85 Nm. Warm drive gear to 80 ° C (Use thermocolour rods if available or suitable temperature measuring device). Differential transmission to transmission -"Set-up Instruction. Tapered Roller Bearing (Differential Housing)".
|
Cover of differential to transmission, |
Sheet metal version |
30 Nm/ 22 lbf. ft. |
|
|
Light alloy version |
18 Nm/ 13 lbf. ft. |
|
|
F 18/F 18+ - transmission 1) |
18 Nm/13.5 lbf. ft. + 30 ° |
|
Fill transmission fluid - see operation "Transmission Fluid Level, Check". |
1) Use new fastening bolts.
|
