Guide Lever, Remove and Install
 Remove, Disconnect Remove selector rod. Press together retaining springs of hollow pin (1) and press out hollow pin (arrow). Replace hollow pin after removal! | 
|
Loosen bolt for shift rod clamp (left arrow). Pin with spring clamps (right arrow) from guide lever mounting. Guide lever assembly from rear engine suspension bracket. | 
|
Both guide lever bearing bushings can be replaced. If necessary, replace joint part on universal joint.
 Important! Do not further disassemble guide lever! | 
|
 Install, Connect Guide lever assy. with pin to transmission, snap in spring clamps. Lubricate bearing bushings, silicone grease. | 
|
Install, Connect Guide lever assy. with pin to transmission. Snap in spring clamps. Lubricate bearing bushings with silicone grease. Connect plug connection shift rod - shift guide. Tighten shift rod clamp bolts only after adjustment. |
|
Knurled bolt of guide lever in shift linkage, do not tighten clamp of transmission shift linkage. New hollow pin at universal joint, snap in expansion springs (1). Lubricate pin with silicone grease. Selector rod.
 Adjust Transmission shift linkage - see operation "Transmission Shift Linkage, Adjust". | 
|
|
