Lock Cylinder for Steering and Ignition Lock,
Remove and Install
Remove
Signal Switch Panelling. Unclip screen wiper switch.
Ignition key to position "I", release lock cylinder (1) and
remove (arrow).
For clearer representation, the illustration shows the area
without steering wheel and immobiliser control unit.
|
|
Install
If the steering lock block pin has engaged, use a screwdriver on
the block stone to put the block pin in the released position
(arrow). Insert lock cylinder in position "I" over catch in
steering and ignition lock casing. Clip on screen wiper switch.
Signal switch panelling.
|