Rear Panelling, Replace (Model L 08, L 48)
Remove
1. |
Remove right and left rear lights
|
3. |
Remove right and left licence plate lamps (arrows)
• |
Disconnect 2x wiring harness plug
|
|
4. |
Release rear panelling
• |
Unscrew 4x right-hand (2) and left-hand (1) outside bolts
|
• |
Unscrew 2x centre bolts (3)
|
|
|
|
5. |
On vehicles with park pilot: release wiring harness plug
(1)
Note: There is no need
to remove the two licence plate lamps.
|
|
|
Important: Danger of damage.
Carefully disengage rear panelling from guide rails. Push side of
rear panelling upwards in the guide rail area and at the same time
pull outwards in direction of arrow.
|
6. |
Detach rear panelling (1)
Note: This requires a
second person
• |
Unclip rear panelling from right guide rail (2)
|
• |
Unclip rear panelling from rear guide rail (3)
|
• |
Unclip rear panelling from left guide rail (4)
|
|
|
|
7. |
When replacing the rear panelling, transfer the attaching parts
|
Install
8. |
When replacing the rear panelling of model L 08 with park pilot
sensor, attach the park pilot sensor bracket
|
9. |
Position rear panelling
Note: This requires a
second person
• |
Route licence plate lamp wiring harness
|
• |
Clip rear panelling into left guide rail
|
• |
Clip rear panelling into rear guide rail
|
• |
Clip rear panelling into right guide rail
|
|
10. |
On vehicles with park pilot: connect wiring harness plug
|
11. |
Attach rear panelling
• |
Tighten 4x bolt, outside right and left 2.5 Nm
|
• |
Tighten 2x bolt, centre 2.5 Nm
|
|
12. |
Install left and right licence plate lamps
• |
Connect 2x wiring harness plugs
|
|
13. |
Attach licence plates
|
14. |
Install right and left rear lights
|
|