|
Replacing rear panelling (model L69)
 Remove
| 1. |
Remove left and right rear light 
|
| 2. |
Remove licence plate lamp
| • |
Remove 2x licence plate lamps
|
| • |
Disconnect 2x wiring harness plug
|
|
|
| 3. |
Release rear panelling
| • |
Unscrew 2x bolts, front top (arrows)
|
| • |
Unscrew 2x front lower bolts (3) and (5)
|
| • |
Unscrew 3x lower rear bolts (4)
|
| • |
Unscrew 6x upper rear bolts (1) and (2)
|
|
|
|
Important: Danger of damage.
Carefully disengage rear panelling from guide rails. Push side of
rear panelling upwards in the guide rail area and at the same time
pull outwards in direction of arrow.
|
| 4. |
Detach rear panelling
Note: This requires a
second person
| • |
Unclip rear panelling from side guide rails and remove
|
|
|
| 5. |
When replacing the rear panelling, transfer the attaching
parts
|
Install
| 6. |
Position rear panelling
Note: This requires a
second person
| • |
Clip rear planning into side guide rails
|
|
| 8. |
Attach licence plate lamp
| • |
Connect 2x wiring harness plugs
|
| • |
Install 2x licence plate lamps
|
|
| 9. |
Install right and left rear lights
|
|
