Test
|
Work Order Description
|
Nominal Value
|
T001
|
Check: Diagnostic Trouble Code stored
|
Is the following Diagnostic Trouble Code stored?
B0085
Replace Driver SIS (Side Impact Sensor)
|
|
|
|
T002
|
Check: Diagnostic Trouble Code stored
|
Is the following Diagnostic Trouble Code stored?
B0085
Incorrect Driver SIS Installed (Side Impact Sensor)
|
|
|
|
T003
|
Check: Component
|
- Check the following component for proper operation:
B63D Sensor - Side Airbag, Driver
|
Test okay?
|
|
T004
|
Check: Short to Voltage of Signal Circuit
|
-
Important:
Before working on the pyrotechnical system: Ignition off Disconnect and mask battery negative terminal Wait 1 min until the capacitor in the control unit has discharged.
- Disconnect wiring harness connector from:
A63 Control Unit - Airbag (Wiring Harness Connector XC18 ) & B63D Sensor - Side Airbag, Driver
- Connect wiring harness connector to:
G1 Battery
- Ignition ON
- Measure voltage between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 39 (XC18) & Ground
|
less than 0.3 V
|
|
|
T005
|
Check: Short to Voltage of Signal Circuit
|
- Measure voltage between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 40 (XC18) & Ground
|
less than 0.3 V
|
|
|
T006
|
Check: Short to Ground of Signal Circuit
|
- Ignition OFF
- Measure resistance between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 40 (XC18) & Ground
|
greater than 500 kOhm
|
|
|
T007
|
Check: Short to Ground of Signal Circuit
|
- Measure resistance between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 39 (XC18) & Ground
|
greater than 500 kOhm
|
|
|
T008
|
Check: Short Circuit in Wiring Harness
|
- Measure resistance between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 39 (XC18) & A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 40 (XC18)
|
greater than 500 kOhm
|
|
|
T009
|
Check: Interruption of Signal Circuit
|
- Measure resistance between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 39 (XC18) & B63D Sensor - Side Airbag, Driver Wiring harness connector (wiring harness side) terminal 1
|
less than 5 Ohm
|
|
|
T010
|
Check: Interruption of Signal Circuit
|
- Measure resistance between the following terminals:
A63 Control Unit - Airbag Wiring harness connector (wiring harness side) terminal 40 (XC18) & B63D Sensor - Side Airbag, Driver Wiring harness connector (wiring harness side) terminal 2
|
less than 5 Ohm
|
|
|