Remove and refit heating control
Note: When replacing
the heater controls with ECC, note the work to be undertaken with
Tech2 when replacing control units.
Remove
2. |
Remove radio
• |
Unclip radio using removal bracket KM-6067
– |
Push removal bracket into the openings (arrows) until it
engages, press outwards and withdraw radio
|
|
• |
Unclip antenna cable (1)
|
• |
Separate wiring harness plug (2)
– |
Release and disconnect wiring harness plug
|
|
|
|
|
3. |
Unclip heating control
• |
Unclip 2x clip at top (1)
|
• |
Separate 2x wiring harness plug (2)
– |
Release and disconnect wiring harness plug
|
|
|
|
|
Install
4. |
Clip in heating control
• |
Connect 2x wiring harness plug
|
|
5. |
Install radio
• |
Connect wiring harness plug.
|
|
7. |
Program volatile memories
Note: When replacing
the control unit, program with TECH2.
|
|