Crankshaft End Play, Check
Note: Engine
dismantled
Install
1. |
Insert 10x crankshaft bearing shell in cylinder block and
crankshaft bearing caps
• |
Note mark and allocation
|
• |
Note position of axial bearing
|
|
2. |
Insert crankshaft into cylinder block
• |
Insert 2x wear ring
Note: Oil grooves point
outwards
|
|
|
|
3. |
Attach 5x crankshaft bearing cap
• |
Note marking, allocation and tightening sequence. Arrows point
to engine timing side
|
• |
Tighten 10x bolt 88.2 Nm
Note: It is not
necessary to replace the bolts when aligning the crankshaft
|
|
|
|
4. |
Attach MKM-571-B
• |
Install MKM-571-B in bracket
|
• |
Attach bracket to cylinder block on the transmission side
|
|
|
|
Measure
5. |
Adjust MKM-571-B
• |
Position plunger on crankshaft flange
|
• |
Attach MKM-571-B with
pre-tensioning
|
|
6. |
Measure longitudinal play of crankshaft
• |
Read off test value
Note: Repeat
measurement several times. Permissible crankshaft end play
|
|
8. |
Remove 5x crankshaft bearing cap
• |
Slacken in the order shown
|
|
|
|
9. |
Remove crankshaft from cylinder block
• |
Take out 2x wearing ring
|
|
10. |
Take 10x crankshaft bearing shell out cylinder block and
crankshaft bearing caps
• |
Note mark and allocation
|
|
|