|
Seal Ring – Rear Crankshaft, Replace
 Remove
| 2. |
Remove clutch pressure plate and carrier disc 
|
| 3. |
Remove flywheel (1)
Note: KM-6263 remains attached to the engine. To provide a
clearer illustration, KM-6263 is not
shown here
|
| 4. |
Check rear crankshaft seal ring, flywheel and starter crown
gear for damage or wear - replace if necessary
|
| 5. |
Clean contact surfaces on crankshaft and flywheel
|
|
|
Important: Do not damage sealing
surfaces
|
| 6. |
Edge out rear crankshaft seal ring with suitable tool
|
| 7. |
Clean sealing surfaces and remove gasket remnants.
|
Install
| 8. |
Install crankshaft rear seal ring
| • |
Coat sealing lip of new seal ring (1) with silicone grease
|
| • |
Push on seal ring with the closed side against KM-235-6 (2)
|
| • |
Push KM-235-6 with seal ring on to
crankshaft journal
|
| • |
Fit KM-658-1 (3) on KM-235-6 (2)
| – |
Knock in seal ring until it sits flush in the housing
|
|
|
|
|
| 9. |
Fit flywheel
| • |
Place flywheel (1) on crankshaft and align
|
| • |
Tighten 6x bolt (3) 35 Nm + 30° +
15°
| – |
Apply screw locking compound
|
|
|
|
|
| 11. |
Install clutch pressure plate and carrier disc
|
|
