Oxygen Sensor, Mixture Regulation, Replace
Remove
2. |
Disconnect battery
• |
Detach ground connection from ground terminal
|
|
3. |
Remove air intake pipe
|
4. |
Undo right front wheel
|
5. |
Raise vehicle by half its height
|
6. |
Detach right front wheel
|
7. |
Raise vehicle by half its height
|
8. |
Detach the lower engine cover and right engine splash guard
|
9. |
Disconnect wiring harness plug for mixture regulation oxygen
sensor (1)
• |
Unclip wiring harness from bracket
|
|
10. |
Remove mixture regulator oxygen sensor (2)
|
|
|
Install
11. |
Install oxygen sensor mixture regulator
• |
Tighten oxygen sensor 45 Nm
|
|
12. |
Connect wiring harness plug for mixture regulation oxygen
sensor
• |
Clip wiring harness into bracket
|
|
13. |
Attach the lower engine cover and right engine splash guard
|
14. |
Lower vehicle by half its height
|
15. |
Attach right front wheel
• |
Screw in 5x wheel bolts
|
|
16. |
Lower vehicle by half its height
|
17. |
Fasten right front wheel
• |
Tighten 5 wheel bolts 110 Nm
|
|
18. |
Fit air intake manifold pipe
|
19. |
Connect battery
• |
Attach ground connection to ground terminal
|
|
20. |
Program volatile memories
|
21. |
Programming the oxygen sensor with Tech 2
|
|