Replace mixture regulator lambda sensor
Remove
2. |
Disconnect earth connection from battery
|
3. |
Remove mixture regulator oxygen sensor (1)
• |
Disconnect wiring harness plug (2)
|
• |
Unscrew carefully with KM-6129
|
|
|
|
Install
4. |
Install oxygen sensor mixture regulator
• |
Coat thread of the mixture regulator oxygen sensor with special
grease
Note: Only if re-using
the oxygen sensor - new oxygen sensors are already pre-treated
|
• |
Tighten oxygen sensor with KM-6129
40 Nm
|
• |
Connect and clip in wiring harness plug
|
|
5. |
Attach earth connection to battery
|
6. |
Program volatile memories
|
|