Result
|
Cause Of Fault
|
E001
|
Result: Defective Component
|
- Defective component:
B69 Air Mass Meter or A84 Control Unit - Engine
Important:
After replacing the following component the programming function for the replacement of the corresponding component has to be performed by using the diagnostic tester:
B69 Air Mass Meter
Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
Note:
The replacement of the components must be done in the listed order.
The system must be checked for proper operation after every replacement.
|
|
E002
|
Result: Short to Voltage
|
- Short circuit to voltage between:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 10 (XC19) & B69 Air Mass Meter Wiring harness connector (wiring harness side) terminal 3
or
- Defective component:
A84 Control Unit - Engine
Important:
Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
|
|
E003
|
Result: Short to Ground/Interruption
|
- Short circuit to ground/interruption of circuit between:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 10 (XC19) & B69 Air Mass Meter Wiring harness connector (wiring harness side) terminal 3
or
- Defective component:
A84 Control Unit - Engine
Important:
Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
|
|
E004
|
Result: Short to Voltage/Interruption
|
- Short circuit to voltage/interruption of circuit between:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 27 (XC19) & B69 Air Mass Meter Wiring harness connector (wiring harness side) terminal 2
or
- Defective component:
A84 Control Unit - Engine
Important:
Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
|
|
E005
|
Result: Interruption
|
- Circuit interruption between:
X125 Underhood Electronic Module Wiring harness connector (wiring harness side) terminal 22 (XE3) & B69 Air Mass Meter Wiring harness connector (wiring harness side) terminal 1
or
- Defective component:
X125 Underhood Electronic Module
Important:
Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
|
|