Servo Motor for Headlamp Range Control AFL,
Replace
Important: High
voltage! Do not touch components in the xenon dipped beam when the
dipped beam is switched on. Ignition and light switch OFF.
Remove
2. |
Open housing cover
• |
Open housing carefully in the central area with a suitable
tool
|
|
|
|
Warning: Do not damage the wiring
harness inside for the headlamp range control servo motor
|
3. |
Partially remove housing cover
• |
Remove housing with a pair of combi-pliers up to approx. 0.5 cm above the preset fracture point
(1)
|
|
|
|
Warning: Do not damage the wiring
harness inside for the headlamp range control servo motor
|
4. |
Remove servo motor
• |
Disconnect wiring harness plug (2)
|
|
|
|
Warning: Do not damage the wiring
harness inside for the headlamp range control servo motor
|
5. |
Remove housing cover
Note: Remove remains of
cover until the new cover can be sealed with positive locking
|
Install
6. |
Insert servo motor
• |
Connect wiring harness plug
|
• |
Clip servo motor into joint head
|
|
8. |
Attach housing cover
• |
Place cover in position
|
|
|
|
|