Liftgate Emblem/Nameplate Replacement (CDTI)
Callout
|
Component Name
|
1
|
Liftgate Emblem
Caution: Refer to
Exterior Trim Emblem Removal
Caution .
Procedure
|
1. |
The part and surface should be 21°C
(70°F)prior to installation. The vehicle should remain 21°C
(70°F)for one hour after assembly to allow adhesive to develop
sufficient bond strength. |
|
2. |
Use a heat gun or equivalent to remove the old
emblem. Clean all adhesive from the rear compartment panel and wipe
the surface dry with a clean lint-free towel prior to installing
the new emblem. |
|
3. |
When removing protective liners from the adhesive
tape, be careful not to touch tape with hands and do not allow tape
to come in contact with dirt or any foreign matter prior to
adhesion. |
|
4. |
Close the rear compartment lid prior to
adhesion. |
|
5. |
Using the palm of the hand, wet out the emblem to
the rear compartment lid to ensure full adhesion of the emblem is
made. |
|
|
| |
|
