Callout
|
Component Name
|
Preliminary Procedures
|
1
|
Rear Wheelhouse Panel Liner Bolt (Qty: 6)
Caution: Refer to
Fastener Caution .
|
2
|
Rear Bumper Fascia Bolt (Qty: 2)
|
3
|
Rear Bumper Fascia
Procedure
|
1. |
Pull the rear bumper fascia rearwards at the front
edge to load the clips on the inboard fascia guides (under the tail
lamp position). |
|
2. |
Release the clips with a suitable tool. |
|
3. |
Continue to pull the rear bumper fascia rearwards
until the outer edges pop outboard. |
|
4. |
Disconnect any electrical connectors as
needed. |
|
5. |
Remove the rear bumper fascia. |
|
6. |
Transfer parts as needed. |
|