|
Operational procedure
|
Paint stage
|
Products
|
Notes
|
| |
I
|
II
|
III
|
|
|
|
Clean
|
|
|
|
|
|
| |
x
|
x
|
x
|
Silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
|
Sand
|
|
|
|
|
|
| |
x
|
x
|
x
|
Wet or dry sandpaper
|
Sand down fault site with grain P600. Give a matt finish to
remaining surface using sanding/matting pad fine, blend prep.
|
|
Putty application
|
|
|
|
|
|
| |
x
|
–
|
x
|
Polyester fine putty, if required
|
Three to four layers of fine putty. Only apply fine putty to the
bare metal sheet.
|
|
Sand
|
|
|
|
|
|
| |
x
|
–
|
x
|
Dry sandpaper
|
Only dry sand with polyester fine putty.
|
|
Clean
|
|
|
|
|
|
| |
x
|
x
|
x
|
Silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
|
Apply filler
|
|
|
|
|
|
| |
x
|
x
|
x
|
2-C-acrylic-HS filler
|
Apply one to three layers of filler with a setting time of 3
minutes. Paint stage II includes minor repairs (no putty
application).
|
|
Sand
|
|
|
|
|
|
| |
x
|
x
|
x
|
Wet or dry sandpaper
|
Grain no less than P800. Grain no less than P360.
|
|
Clean
|
|
|
|
|
|
| |
x
|
x
|
x
|
Silicone remover
|
Remove dust with tack cloth.
|
|
Spray top coat paint
|
|
|
|
|
|
| |
x
|
x
|
x
|
2-C-acrylic top coat paint
|
Pre-spray one layer. Setting time 3 to 5 minutes. Final spraying
with one more layer. Setting time 5 minutes prior to oven
drying.
|
